Removal and installation the master brake cylinder (Opel Vivaro A)

Removal

1. Disconnect the wiring connector from the brake fluid level sensor, remove the brake and clutch hydraulic fluid reservoir cap.

2. Place a container under the master cylinder to collect the used brake fluid.

3. Disconnect, collecting the used brake fluid, the clutch master cylinder pipe A, brake pipes B, brake pipes C (on cars without ABS) (figure 8.1).



(Article posted on an online resource: OpelBook.ru)

4. Unscrew the brake and clutch hydraulic fluid reservoir mounting bolt, remove the brake and clutch hydraulic fluid reservoir, unscrew the brake master cylinder mounting nuts D and remove the brake master cylinder.

Installation

5. Installation is carried out in the reverse order of removal.