Contents: Removal ⬇ Installation ⬇
Removal
Raise the vehicle and support it on supports.
Remove the rear wheels.
If removing only the left upper arm, remove the fuel tank (see the relevant chapter).
Remove the bolt and disconnect the wheel speed sensor wire from the upper arm.
Remove the bolt and the ABS sensor wire bracket.
Loosen the nuts, remove the bolts and remove the upper arms, keeping in mind that only the left arm has a protective washer (arrow).
Installation
Install the upper rear suspension arms onto the vehicle, making sure they are installed correctly, and secure with bolts and nuts, tightening them to 137 Nm.
Install the ABS sensor wire bracket and secure it with the bolt.
Attach the ABS sensor wire to the upper control arm.
Install the fuel tank (see the relevant chapter).
Install the rear wheel.
Lower the car.
Visitor comments