Front door trim (Opel Frontera B)

Removal

Disconnect the cable from the negative battery terminal.

On a vehicle with power windows, remove the window control switch.

On a vehicle with manual windows, close the window completely and mark the location of the window handle. Release the mounting bracket and remove the handle. The bracket is released by inserting a clean cloth between the handle and the door trim and, by pulling the cloth opposite the ends of the bracket, hooking the bracket and releasing it. In this case, you need to pull the handle towards you so that after releasing the bracket, it comes off the window regulator splines.

Pull the inner door lock release handle, remove the screw, remove the handle from the door trim and disconnect the rod from it.



Remove the outside rearview mirror inner decorative cover, inner door handle cover and speaker grille.



Remove the speaker from the door trim and disconnect the electrical connector from it.

Use a wide-blade screwdriver to pry the door trim away from the door, then disconnect the connectors from the tweeter, footwell lamp, and remove the door trim.

Remove the footwell light and tweeter from the front door trim.

Remove the dust and moisture protection film from the front door.

Note: Remove the door dust and moisture protection film carefully so that it can be reused.

Installation

Install a dust and moisture protection film on the front door.

Install the footwell light and tweeter to the front door trim.

Connect the connectors to the tweeter and the courtesy light, then install the door trim to the front door and make sure the trim is securely fastened with clips.

(Source is on this resource: «www.opelbook.ru»)

Connect the connector to the speaker and install the speaker into the front door trim.

Install the speaker grille, inner door handle cover and outside rearview mirror inner decorative cover.

Connect the rod to the inside door lock release handle, install the handle on the door and secure the handle with a screw.



Connect the connector to the power window control switch.



Install the window switch or control handle into the front door trim.

Connect the cable to the negative terminal of the battery.