Lay cable duct 1 aside.
Unfasten the cable duct.
Squeeze out from the control lever a cable of a drive of a gear change 3.
Release from the holder a cable of a drive of a gear change.
Pry out the retaining clip 2 with a screwdriver.
wring out (arrow) shift cable from the control lever on the shift lever position switch.
Release the gearshift cable from the stop.
Pry off the locking clip with 1 screwdriver.
Pull the gearshift cable 3 away from the rubber seal 4 on the end panel.
Note. Make sure that the rubber seal does not come off the end panel.
Insert the shift cable 1 through the end panel from below and route it as required.
Moisten the rubber seal 2 of the shift cable with soapy water.
Insert into the stop and fix the cable of the gear shift drive in it.
Push in the locking clip.
Note. Check for correct fixation.
Press in (arrow) shift cable on the shift lever position switch control lever.
Press the shift cable 2 onto the shift lever 3.
Insert the shift cable 2 into the holder inside the vehicle.
Secure with retaining clip 1.
Fix cable duct 4.
Install the center console.
Adjust the shift cable system.
Check the reliability functions of the shift lever.
Visitor comments