Removal and installation the heater fan drive motor (Opel Corsa C)

Corsa C models

1. The reason for the fan failure at any speed is usually a faulty resistive assembly - replace the assembly.

2. On models not equipped with an A/C system, remove the fan motor, (see Section 12).

3. Unlock and disconnect the resistor assembly wiring connector (see accompanying illustrations).

13.3a. Removing the resistive assembly (4) on models without a K\V system (corsa C models) - the arrows indicate the electrical wiring connector clamps: 1. Locking lever; 2. Electrical wiring connector; 3. Guides

13. Zb. Removing the resistive assembly on models equipped with the K\V system (corsa C models): 1. Locking lever; 2. Electrical wiring connector

4. Press the locking lever (see illustration 13.3) and move the resistive assembly so that its guides coincide with the grooves in the housing. Remove the resistive assembly.

Note: If equipped with climate control, press the 2 latches and remove the regulator.

5. Installation is performed in the reverse order of removal. Check the reliability of the resistive assembly fixation.

Meriva Models

6. Unlock and disconnect the resistor assembly wiring connector (see illustration 12.13).

7. Remove the mounting screw (see illustration 12.13) and remove the assembly from the fan motor housing.

Article posted on an online resource OPELBOOK.ru

Note: If equipped with climate control, press the 2 latches and remove the regulator.

8. Installation is performed in the reverse order of removal. Check the reliability of the resistive assembly fixation.