Removal / installation of side and central deflectors
1. Install the appropriate deflector so that its nozzles point as far down as possible.
2. Enter from the top of the rounded side of the deflector (see resist. illustrations) plastic wedge (e.g. Hazet 1965-20) and remove the deflector from the outer holder (arrow).
10.2a. Removing the side deflector with a plastic wedge (1) (Corsa C models) | 10.2b. Removing the central deflector with a plastic wedge (1) (Corsa C models) |
3. Align the deflector relative to the mounting socket, remove it from the inner holder and remove it from the instrument panel.
4. When installing, first install the deflector on the inner holder (see resist. illustration), and then click on it and lock on the outer one.
10.4. Deflector holders: A - internal, B - external (Corsa C models)
Removal / installation of the housing of the central air deflectors
5. Remove center deflectors (see above).
6. Remove the hazard switch (see chapter 12).
7. Remove the 4 screws securing the case (see resist. illustration).
10.7. screws (indicated by arrows) fixings of the housing of the central deflectors (Corsa C models)
8. Take the case of the central deflectors by the lower part, pull it forward and slightly up and remove it from the instrument panel.
9. Disconnect the alarm switch connector from the back of the housing (see resist. illustration).
10.8. Disconnect the wiring connector from the back of the case (1) central deflectors in the direction indicated by the arrow (Corsa C models)
10. Installation is made in an order, the return to an order of removal. At the same time, make sure that the hazard warning switch wiring harness is in the correct position.
Visitor comments