Contents: Corsa Models ⬇ Meriva Models ⬇
Corsa Models
1. Disconnect the cable from the negative terminal of the battery (see Chapter 5).
2. Remove the central instrument panel deflectors (see Chapter 3).
3. Carefully pry up and remove the decorative switch button (see accompanying illustration).
26.3. Removing the decorative button (1) of the hazard warning switch (corsa models)
4. Press the switch with a screwdriver (see accompanying illustration) and separate it from the console section of the instrument panel. Disconnect the wiring connector from the back of the switch.
5. Installation is performed in the reverse order of removal. Please note that when installing the switch, the LED should be on top.
Meriva Models
6. Disconnect the cable from the negative terminal of the battery (see Chapter 5).
26.4. Press the hazard warning switch at the indicated points (arrows) and remove it from the panel (corsa models)
7. Using a plastic wedge, press the side clips and remove the hazard warning light switch panel (see accompanying illustration).
26.7. Using a plastic wedge (2), press the clamps (indicated by arrows) switch panels (1) of the emergency signaling (meriva models)
Note: This panel also contains the switches for the front seat heating (with appropriate equipment).
8. Disconnect the wiring connector from the back of the switch.
9. Installation is carried out in reverse order.
Visitor comments