Removal and installation speakers (Opel Corsa C)

Front full-range speakers

Note: The front speakers are secured in the door assemblies. On Meriva models the rear speakers are located in the rear door assemblies and are removed in the same way.

1. To access the speaker, remove the trim of the corresponding door (see Chapter 11). On Meriva models, partially remove the insulating film from the door frame.

2. Remove the 3 mounting screws (see accompanying illustration) and remove the speaker, then disconnect the wiring connector.



3. Installation is carried out in reverse order.

Rear full-range speakers (corsa models)

Note: On these models, the rear full-range speakers are integrated into the luggage compartment trim panels.

4. Open the tailgate and remove the trim of the corresponding luggage compartment side panel (see Chapter 11).

5. Disconnect the speaker connector.

6. Remove the 3 mounting screws (see accompanying illustration) and remove the speaker.





7. Installation is carried out in reverse order.

High frequency loudspeakers

Corsa Models

8. Remove the front door triangle trim (see Chapter 11).

9. Press the latches on the back of the cover and remove the speaker from the socket (see accompanying illustration), disconnect the high frequency speaker wiring connector.



10. Installation is carried out in reverse order. Make sure that the speaker is in the correct position.

Meriva Models

11. Remove the inner door handle cover (see Chapter 11, Section 23).

12. Press the latches and remove the tweeter (see accompanying illustration), disconnect the electrical wiring connector.



13. Installation is carried out in reverse order.