Contents: Corsa Models ⬇ Meriva Models ⬇
Note: The condition of the information display is checked using a special diagnostic device. Based on this check, it is determined whether it needs to be replaced.
Corsa Models
1. Remove the central air deflectors housing (see Chapter 3).
2. Remove the 2 mounting screws (see accompanying illustration) and remove the information display together with the visor from the instrument panel.
24.2. Screws (indicated by arrows) information display mounts (1) (corsa models): 2. Hazard warning switch connector
3. Press the latch on the back of the display, pull up the locking clip and disconnect the wiring connector.
4. Remove the 2 screws on the back of the display and separate the visor.
5. Installation is carried out in reverse order.
Meriva Models
6. Using a plastic wedge, separate the decorative panel of the information display trim and remove it from the instrument panel.
7. Remove 2 mounting screws, release the display from the lower clips (see accompanying illustration) and remove it from the dashboard.
24.7. Screws (2) for fastening the information display (1) (meriva models) - the arrows indicate the clamps
8. Installation is carried out in reverse order.
Original posted on the website: www.opelbook.ru
Visitor comments