Engines 1.4, 1.6 and 1.8 liters
1. Raise the front of the car, drain the engine oil.
2. Disconnect the connector from the sensor, unscrew 4 screws and remove the sensor from the pallet (see photo). When assembling, replace the O-ring.
Engine 2.0L
3. Raise the front of the car, drain the engine oil.
4. Disconnect the connector from the oil level sensor in the sump, remove the bracket and push the sensor connector into the sump.
5. Turn away bolts, remove the bottom section of the pallet and get the gauge, having turned away 2 bolts.
6. Installation is carried out in the reverse order. When reassembling, replace the sensor O-ring.
Visitor comments