2. Remove the filler cap and pump out all the fuel.
3. Block the front wheels, then jack up the rear of the car and secure it on axle stands. Disconnect the wiring from the fuel level sensor.
4. If the sensor includes supply and return hoses, mark them, loosen the clamps and disconnect.
5. Where the metal ring is installed, use two screwdrivers to turn it counterclockwise. Where the bolts are installed, unscrew them. Remove the metal ring and the sensor.
6. Remove the O-ring or gasket.
7. Clean the contact surfaces of the sensor and the fuel tank.
8. Where available, apply a small amount of multi-purpose grease to the new O-ring and position it in the sensor groove.
9. Install the sensor into the tank with the suction tube facing down. Use a new gasket.
10. Where the ring is applied, tighten it completely clockwise.
11. Where bolts are used, apply thread locking agent to the threads, insert and tighten them in a diagonal sequence.
12. Install the hoses and wiring, connect the negative battery cable. Lower the car to the ground.
13. Fill the tank with fuel, install the filler cap.
Visitor comments