1. Disconnect the negative battery cable.
2. Remove the air filter as described in Chapter 4.
3. Drain the liquid from the cooling system (Section 2) or install clamps on the automatic choke coolant hoses.
4. Loosen clamps, disconnect coolant hoses from auto choke cover.
5. Loosen the clamps, disconnect the fuel supply and, if present, the return hose (And).
6. Disconnect the accelerator cable (Chapter 11).
7. Disconnect the electrical wiring from the shut-off valve, thermostatic valve, and automatic air damper.
8. Note the location of the vacuum hoses, then disconnect them.
9. Turn off nuts, then lift the carburetor from racks. Remove the gasket.
10. Installation is carried out in the reverse order, if necessary, use a new gasket. Adjust the accelerator cable as described in Chapter 11. Fill the cooling system (Section 2) and install the air filter (Chapter 4).
Visitor comments