Side jack: It should always be installed on a solid base. If necessary, place a solid board underneath.
Diamond Jack: It is recommended to purchase a stable model with a wide base and as long a crank handle as possible.
Hydraulic plunger lift: there are inexpensive models. Its advantage is that it can quickly lift a car. Before buying, you need to check the lifting height: if the lift is too low, the wheels will not be raised to the required height from the ground. And a lift that is too high cannot be installed under the bottom of the car.
Left: the jack can only be installed at the mark stamped in the metal on the body fold. This applies to both the front and rear of the car. Right: don't forget about a support when working on a car! A tripod like this works well. A wooden block that distributes the load, as a gasket, will protect the anti-corrosion coating and the bottom of the car.
Jacks may only be installed at these points:
A - jack receiving point in the workshop;
B - receiving point for the side jack.
Mobile jack: even more practical is the same model with an additional pedal for lifting. For a car enthusiast, a short, small mobile jack that does not take up much space is best. And you should pay attention to the fact that a lift with too small wheels is difficult to move under a heavy load, and that the leash mount can withstand the maneuvering process.
Tip: Place a piece of wood between the jack head (except for the side jack) and the bottom of the car, better distributes the load and prevents possible damage to the bottom of the car.
Visitor comments