Arrangement of bolts of fastening of a back casing of a gear belt to a head of the block of cylinders
1. Remove the camshaft pulley.
2. Remove the cylinder head rear toothed belt cover bolts and move the toothed belt cover as far away from the head as possible. For best access to the camshaft oil seal, completely remove the rear toothed belt guard.
3. Drill two small holes in the ends of the o-ring. Screw in the two self-tapping screws and use the pliers behind the screw heads to pull the O-ring out of the socket.
4. Clean the sealing ring seat and the sealing surface of the camshaft.
5. Lubricate the new O-ring with clean engine oil and, using a pipe drift, install it in place.
6. Screw in bolts of fastening of the top part of a back casing of a gear belt to a head of the block of cylinders.
7. Install the camshaft pulley.
Visitor comments