Models without headlight washer
Removing
2. Disconnect wiring and hose from pump.
3. Remove the pump from the reservoir.
4. Inspect the condition of the O-ring and replace it if necessary. Clean the strainer at the end of the suction tube of the pump.
Installation
5. Installation is carried out in the reverse order.
Models with headlight washer
6. Apply the handbrake, then jack up the front of the vehicle and place it on axle stands.
7. Turn off screws of fastening and take plastic facing from a forward bumper/wing.
8. Remove wheel arch protection (Section 11).
9. Proceed as described in points 2-5 inclusive.
Visitor comments