Removing
1. The factory standard electrically operated antenna can be replaced separately from the antenna unit.
2. Turn on the radio until the antenna is fully extended.
3. Loosen the mounting nut.
4. Lift the spring sleeve up and release its lower end.
5. The assembly can now be removed from the mechanism by pulling it up.
Installation
6. Insert the spherical pin of the antenna assembly into the base.
7. Gently push the antenna down as far as possible until it locks into the mechanism (see illustration).
8. Turn off the radio to lower the antenna.
9. If the antenna does not fully lower into the base, manually lower it.
10. Insert the spring sleeve into the base and tighten the mounting nut.
11. Check the operation of the antenna by turning the radio on and off several times.
Visitor comments