On-board computer components — removal and installation (Opel Vectra A)

1. Disconnect the battery cable.

Display module

Removal

2. Using a thin screwdriver, carefully remove the module from the dashboard.

3. Disconnect the wire contact and remove the module.

Installation

4. Installation is carried out in reverse order.

Display module illumination lamp

Removal

5. Remove the display module as described previously in this Chapter.

6. Using a long rubber tube of the appropriate diameter, remove the lamp by inserting the tube through the hole on the side of the display module (see illustration).

Installation

7. Installation is carried out in reverse order.

Control switch

Removal

8. Remove the rear section from the center console as described in Section 11.

Text was copied from the portal: www.opelbook.ru

9. Using a screwdriver, disconnect the wire contact from the switch.

10. Lift the switch up and then slide it down away from the central console.

Installation

11. Installation is carried out in reverse order.

External air temperature sensor

Removal

12. The sensor is located on the left end of the front bumper (see illustration).





13. Using a lever, remove the bumper trim cover, then unfasten the sensor and disconnect the wire contact.

Installation

14. Installation is carried out in reverse order.