Removing
1. Block the front wheels then jack up and support the rear of the vehicle on axle stands
2. Unscrew and remove the nuts and bolts securing the ends of the anti-roll bar to the trailing arms (see illustration).
3. Loosen and remove the nuts and bolts securing the anti-roll bar clips to the torsion beam, and remove the anti-roll bar from under the vehicle (see illustration).
4. Inspect stabilizer mounting bushings for signs of wear and damage and replace as needed.
5. To replace the bushings, pull them off the ends of the stabilizer.
Installation
6. Install in reverse order.
7. Tighten all fasteners with the tightening force specified in the Specifications.
Visitor comments