Removing
1. To remove the tank from the mounting bracket, unscrew the screw and remove the clip.
2. Substitute a suitable container to catch the liquid, then disconnect the hoses from the reservoir and drain the liquid.
Seal the ends of the hoses to prevent dirt from entering and further loss of fluid.
3. If required, the mounting bracket can be unscrewed from the body panel. Note that on some models, the bolts securing the bracket also secure the ignition coil (see Section 5). Before removing, unfasten the brake pipes and wiring from the bracket.
Installation
4. Install in reverse order. Finally, bleed the hydraulic line (Chapter 39).
Visitor comments