Contents: Removal ⬇ Installation ⬇
Removal
1. Using a 2.5mm drill bit, drill a hole in the cuff.
2. Screw the bolt into the cuff and pull it out with pliers (figure 5.28).
Figure 5.28. Screw a bolt into the cuff and pull it out with pliers.
Installation
3. Install a new seal with a protective ring using tool B.Vi. 1236 (figure 5.29).
Figure 5.29. Install a new cuff with a protective ring using tool B.Vi. 1236.
Original posted on the website (opelbook.ru)
4. Remove the protective ring. Install the clutch release bearing guide sleeve into place.
Visitor comments