| Gearbox type | MUA5C |
| Gear ratios: - 1st gear | 3,767 |
| - 2nd gear | 2,248 |
| - 3rd gear | 1,404 |
| - 4th gear | 1,00 |
| - 5th gear | 0,809 |
| - reverse gear | 3,873 |
Lubricants
| Transmission oil: - quality | aPI-SF, SG motor oil |
| - viscosity - for vehicles operated at temperatures below 32°C | SAE 5W-30 |
| - for vehicles operated at temperatures above 32°C | SAE 40 or 50 |
| Oil volume, l: - gearbox housing | 2,95 |
| - transfer case | 1,45 |
Note: The transmission oil level should be at the lower edge of the oil filler hole.
Tightening torques of threaded connections, N·m
| Bolt for fastening the retaining plate of the housing with the driven gear of the vehicle speed sensor | 15 |
| Vehicle speed sensor | 27 |
| Transfer case control lever mounting bolts | 25 |
| Gear Shift Lever Retaining Plate Mounting Bolts | 25 |
| Gear shift lever protective boot mounting screws and nuts | 9 |
| Input shaft cover mounting bolts | 25 |
| Clutch release fork bracket to front crankcase mounting bolts | 38 |
| Flywheel inspection cover mounting bolts | 11 |
| Gearbox mounting bolts to engine 6VD1-W (see the corresponding figure in the text): -bolts A | 76 |
| - bolts B | 40 |
| - bolts C | 8 |
| - 2 bolts D | 8 |
| Gearbox to engine mounting bolts X 22 SE: -bolts M12 | 76 |
| - M10 bolts | 40 |
| -bolts 6 | 8 |
| - D bolts | 60 |
| Gearbox to engine mounting bolts X 22 DTH (see the corresponding figure in the text): -bolts A | 76 |
| - bolts B | 40 |
| - 2 bolts C | 8 |
| Bolts for fastening the rear beam to the vehicle chassis | 76 |
| Gearbox support to rear beam mounting nuts | 50 |
| Clutch slave cylinder mounting bolts | 40 |
| Bolts for fastening the cover that closes the clutch housing | 6 |
| Bolts and nuts for fastening the flanges of the front propeller shaft to the transfer case and front axle | 63 |
| Bolts and nuts for fastening the flanges of the rear propeller shaft to the transfer case and rear axle | 63 |
| Transfer case rear housing mounting bolts | 37 |
| Bolts securing the retainer plate to the intermediate plate | 20 |
| Main shaft bearing retaining plate mounting bolts | 15 |
| Main shaft nut | 137 |
| Transfer case mode shift drive mounting bolts | 19 |
| Bolt and nut for fastening the heat-protective casing of the transfer case mode switching drive | 19 |
| Transfer case driven shaft front flange fastening nut | 137 |
| Bolts and nuts for fastening the front suspension beam to the chassis | 82 |
| Transfer case driven shaft rear flange fastening nut | 167 |
Visitor comments