2. Release the locking strip and remove the bellows from the worn joint.
3. Extend the snap ring that secures the joint to the drive shaft (Pic. 7.4).
Pic. 7.4. Drive shaft joint retaining spring ring - indicated by arrow
4. Knock the joint out of the drive shaft using a hammer with a plastic head (Pic. 7.5).
Pic. 7.5. Removing the joint from the drive shaft
5. Install the new hinge by tapping until the snap ring fits into its groove.
6. Lubricate the joint with the specified lubricant.
7. Install the bellows as indicated in previous Section.
8. Install the drive shaft to the machine.
Visitor comments