Contents: Windshield ⬇ Rear window ⬇
Windshield
Corsa Models
1. Remove the fairing grille (see Chapter 11).
2. Alternately press the clamps and push out the injectors (see accompanying illustration) from the landing nests.
7.2. Windscreen washer nozzle supply hose (2) (corsa C models) - the arrow indicates the lock
3. Installation is performed in the reverse order of removal. If necessary, adjust the direction of the washer fluid jet on the windshield by inserting the needle into the corresponding nozzle of the injector (service stations use the Hazet 4850-1 device) and direct the nozzle to the desired point.
Meriva Models
4. Open the hood.
5. Press the fasteners using a screwdriver (see accompanying illustration) and pull the washer nozzles out of the hood from its lower side. Disconnect the supply hoses from the nozzles.
7.5. Press the retainer clips (3) of the windshield washer nozzle (1) in the direction indicated by the arrows (meriva models): 2. Supply hose
6. Installation is carried out in the reverse order of removal. If necessary, adjust the direction of the washer fluid jet by directing the nozzles with a needle to the desired points on the windshield.
Rear window
Corsa Models
7. On Corsa C models, insert the plastic wedge (for example, Hazet 1965-20) between the rubber seal and the washer nozzle (see accompanying illustration) and carefully separate the nozzle.
(Material provided by this website OpelBook.ru)
7.7. Separating the rear window washer nozzle (1) from the rubber seal (2) using a plastic wedge (corsa C models)
8. Pull out the nozzle and disconnect the supply hose from it.
9. On Corsa Combo models, the jet is installed in the high-level brake light. Remove the brake light (see Section 19) and using a plastic wedge, separate the washer nozzle.
10. Installation is carried out in reverse order.
Meriva Models
11. On these models, the rear window washer nozzle is built into the high-level brake light and can only be removed together with it (see Section 19).
Visitor comments