Note: The high-level brake light is made using LEDs. Individual LEDs cannot be replaced; the entire assembly must be replaced if necessary.
Corsa C models
1. Set the rotary switch for the outdoor lighting modes to the "O" position (see Chapter "Controls and operating techniques", Section 17) and turn off the ignition. Disconnect the battery (see Chapter 5).
2. Open the tailgate and pry it out with a plastic wedge (for example, Hazet 1965-20) high level brake light retainer.
3. Disconnect the wiring connector and remove the brake light from the tailgate.
4. Press the latches and remove the LED holder (see accompanying illustration) from the brake light assembly.
19.4. Fixators (indicated by arrows) lED holder (corsa C models)
5. Installation is carried out in reverse order. Check the proper functioning of the signal.
Corsa Combo Models
6. Press the high level brake light cover out of the clips (see accompanying illustration) and remove it together with the brake light.
19.6. Fasteners (1) for fastening the cover of the high-level brake light and fasteners (2) for fastening the signal to the cover (corsa Combo models)
7. Disconnect the high level brake light wiring connector.
8. Press the 2 latches and separate the cover from the brake light assembly (see illustration 19.6).
9. Installation is carried out in the reverse order. Check the correct functioning of the brake light.
Meriva Models
10. The method of fastening the upper level brake light assembly and the procedure for removing it are shown in the accompanying illustration.
19.10. Removing the upper level brake light (1) (meriva models) - the arrows indicate the directions for pressing the connector lock (3) of the electrical wiring and removing the hose (4) for supplying the rear window washer fluid: 2. The rear window washer nozzle is built into the brake light assembly
(Original posted on the website: opelbook.ru)
Visitor comments