Replacing the fog light bulb (Opel Corsa C)

1. If necessary, raise the vehicle on a lift or place it on stands.

2. Turn the cap on the back of the fog light counterclockwise (see illustration 15.2a) and remove it. Then release the spring clip from the holders, remove the lamp from the socket and disconnect the wiring connector (see illustration 15.2b).

15.2a. Rear cover (1) of the fog lamp

15.2b. Wire spring clip (2) and connector (3) for fog lamp wiring

3. Replace the bulb, install the bulb into the socket and, holding it with your finger, secure the wire spring clip into the holders with your other hand. Connect the wiring connector.

4. Replace the lamp cover, lower the vehicle and check that the lamp is functioning properly.