Contents: Corsa C/Meriva models ⬇ Corsa Combo Models ⬇
Corsa C/Meriva models
Removal and installation the lampshade
1. Set the rotary switch for the outdoor lighting modes to position "0" (see Chapter "Controls and operating techniques", Section 17) and turn off the ignition. Disconnect the battery (see Chapter 5).
2. Insert a screwdriver into the frame of the license plate light on the right side (see accompanying illustration), press the retaining spring and remove the lamp from the rear bumper.
20.2. Removing the license plate light (corsa C/Meriva models) - the arrow indicates the direction of spring compression
3. Disconnect the license plate light wiring connector.
4. Installation is carried out in the reverse order. Check the proper functioning of the lamps.
Replacing the lamp
5. Remove the license plate light (see above).
6. Turn the lamp holder counterclockwise (see accompanying illustration) and remove it together with the bulb from the flashlight housing. Replace the bulb.
20.6. To remove the license plate light bulb from the lamp assembly, turn the bulb holder counterclockwise (corsa C/Meriva models)
7. Installation is carried out in reverse order.
Corsa Combo Models
8. On these models, the license plate light is secured with two screws - remove the screws and remove the corresponding light (see accompanying illustration).
20.8. Loosen the mounting screws and remove the license plate light (corsa Combo models)
9. Press the spotlight lamp against the spring clamp and remove it from the lampshade. Replace the lamp.
10. Installation is carried out in reverse order.
Visitor comments