1. Remove the crankcase protection (see Removal and installation of mudguards and engine crankcase protection).
2. Place a jack or support under the crankcase.
3. Turn out a bolt of fastening of a support to an arm on a transmission …
4.... and remove it.
5. While holding the bolts from turning, unscrew the nuts of the two bolts securing the support to the subframe, remove the bolts from the holes of the support and subframe..
Note. For clarity, shown on the removed subframe.
6.... and remove the support.
7. Inspect the support pad. If there is swelling, cracking of the rubber mass, its delamination from the metal cage, or if cracks appear in the cage, replace the support assembly.
8. Turn out three bolts of fastening of an arm of a support to a transmission …
9.... and remove the bracket.
10. Inspect the support bracket. In the presence of cracks or ovality of holes for fastening parts, replace the bracket.
11. Install the removed parts in the reverse order of removal.
Visitor comments