Note. To remove any suspension support of the power unit, it is necessary to install the car on an inspection ditch or hang it on a lift.
You will need a socket «at 15».
Note. The left suspension support of the power unit is attached with three bolts to the body side member and with three bolts to the bracket on the gearbox.
1. Remove the battery (see Removing and installing the battery).
2. Remove the battery mounting shelf (see Removal and installation of the shelf of fastening of the rechargeable battery).
3. Remove the left front wheel liner (see Removal and installation of fender liner).
4. Place a jack or support under the crankcase of the engine or gearbox.
5. Turn out three bolts of fastening of a support to an arm on a transmission..
6.... and three bolts of fastening to the side member of the body.
7. Remove the support.
8. Turn out three bolts of fastening of an arm..
9.... and remove the bracket.
10. Inspect the support pad. If there is swelling, cracking of the rubber mass, its delamination from the metal cage, or cracks in the cage, replace the support assembly.
11. Inspect the support bracket. In the presence of cracks or ovality of holes for fastening parts, replace the bracket.
12. Install the left powertrain mount in the reverse order of removal.
Visitor comments