You will need: socket heads "10", "13", pliers with thin jaws.
1. Remove the battery (see Removal and installation the battery).
2. Remove the engine control unit (see Removal and installation of the electronic engine control unit).
3. Pulling up…
4. …remove the engine control unit bracket.
5. Press the release button to disconnect the wiring harness connector from the non-contact current sensor.
Original posted on the website: OPELBOOK.ru
6. Loosen the nut securing the ground wires…
7. …unscrew the nut…
8. ...and remove one from the pin...
9. …and the second tips of the "ground" wires.
10. Remove the ground wire from the current sensor hole.
11. Press the current sensor lock with a screwdriver…
12. …and remove the sensor from the battery shelf bracket.
13. Use pliers to squeeze the clips of the middle holder of the engine wiring harness…
14. …and disconnect the holder from the battery shelf bracket.
15. Similarly, disconnect the upper holder of the power wiring harness from the shelf…
16. …its lower holder…
17. …and the front engine harness holder.
18. Pry the edge of the pipe holder retainer towards the heater…
19. …unfasten the retainer…
20. …and remove the pipeline from the rear holder on the battery mounting shelf…
21. …and then from the front holder.
22. Use pliers to squeeze the rear engine harness bracket clips…
23. …and disconnect the harness from the battery mounting shelf.
24. Remove the three bolts securing the battery tray to the body…
Note: This is how the shelf mounting bolts are located.
25. …and remove the shelf.
26. Install the battery mounting shelf and all removed parts in the reverse order of removal.
Visitor comments