You will need: end head «on 10», pliers with thin jaws, a screwdriver with a flat blade.
1. Open the hood and place it on the stop.
2. Remove the levers from the windshield wiper trapezoid drive shafts (see Removal and installation of levers of a screen wiper of a windscreen).
3. Remove the hood seal from the flanging of the bulkhead.
4. Pry up with a screwdriver, push up the latches of the six caps for securing the air intake grille..
Note. This is how the caps for fastening the grille of the air intake box are located.
5.... and remove the caps.
6. Disconnect the central part of the grille from the box..
7.... and turn it upside down first.
8. Disconnect the fluid supply hose from the fitting of the left washer jet and remove the central part of the air intake box grille.
9. Remove the left and right parts of the air box grille.
10. Prying with a screwdriver, push forward the retainer of the piston for fastening the drainage casing..
11.... and remove the piston.
12. Remove the two stops at the bottom of the drain cover from the holders on the wiper guard..
13.... and remove the drainage cover.
14. Turn out on two bolts of fastening of a protective casing of a screen wiper at the left …
15.... and on the right.
16. Squeeze the clamps of the central holder of the protective cover of the wiper with pliers..
17.... remove the holder rod from the bracket hole on the body..
18.... and remove the wiper guard.
19. Install the shrouds and airbox grille in the reverse order of removal.
Visitor comments