You will need: socket TORX E11, extension, wrench, flat blade screwdriver.
1. Disconnect the wire from the terminal «minus» battery.
2. Remove the ignition module (see Removal and installation of the ignition module).
3. Overcoming resistance of clamps, disconnect the holder of a motor plait of wires from a cover of a head of the block of cylinders.
4. Turn out nine bolts of fastening of a cover of a head of the block of cylinders …
Note. This is how the cylinder head cover bolts are located.
5.... and remove the cover
6. Remove the gasket from the slots in the cover.
7. Clean the slots in the cover and install a new gasket in them.
8. Establish a cover of a head of the block of cylinders in an order, the return to removal.
Bolts of fastening of a cover of a head of the block of cylinders tighten evenly crosswise the moment of 8–10 Нм.
Visitor comments