The ignition module is a unit that combines four ignition coils (one coil for each spark plug). The module is non-separable, cannot be repaired, and if at least one ignition coil fails, it must be replaced as a whole.
You will need a TORX T40 key.
1. Remove the ignition module protective cover, overcoming the elastic resistance of the clamps, by sliding it to the right and up.
2. Press the locking tab of the module wiring harness connector…
3. …and disconnect the connector from the module.
4. Remove the two bolts securing the ignition module to the cylinder head…
5. …and remove the module, overcoming the elastic resistance of the clamps of its tips on the spark plugs.
6. Install the parts in the reverse order of removal.
Visitor comments