1. Disconnect the wire from the terminal «minus» battery.
2. Remove the air intake grille and wiper guard (see Removal and installation of a lattice of a box of an air inlet).
3. Squeeze the antennae of the harness holder with pliers..
4.... and disconnect the wiring harness from the wiper trapezoid.
5. Turn out bolts of the right …
6.... central..
7.... and the left wiper trapezoid mounts.
8. Take the trapezoid away from the body.
9. Squeeze the latch..
10.... disconnect the wiring harness block from the wiper gearmotor..
11.... and remove the wiper trapezoid assembly with the gearmotor.
12. Mark the relative position of the crank and the gearmotor shaft so that the trapezoid adjustment is not disturbed during reinstallation.
13. Turn away a nut of fastening of a crank and disconnect it from a motor reducer shaft.
14. Turn out three screws of fastening..
15.... and disconnect the gearmotor and the trapezoid.
16. Install the parts in the reverse order of removal.
Visitor comments