To perform the work, an inspection ditch or overpass is required.
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. In any way possible (for example, with a regular jack through a wooden block) raise the engine, unloading the rear support.
3. Holding the nut from turning with a 18 mm key, with a long TORX T55 key, unscrew the bolt securing the gearbox bracket to the support.
4. With a 16 mm wrench, unscrew the fastening nut.
5. Using two 16 mm wrenches, unscrew the nut, remove the coupling bolt and remove the support.
6. Install the parts in reverse order. Tighten nuts and bolts to specified torque (see «Reference data»).
Visitor comments