Warning! Before performing the operation, be sure to read the section «Safety measures for the maintenance and repair of the engine management system».
Execution sequence
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Remove the lower lining of the instrument panel (see «Brake light switch - replacement and adjustment»),
3. Disconnect the drive cable from the throttle control pedal by pulling it up.
4. Disconnect the cable from the throttle actuator lever and bracket (see «Throttle assembly - removal, gasket replacement and installation»).
5. If the car is equipped with an automatic transmission, disconnect the sensor wiring harness block «kickdown», built into the throttle cable.
6. Remove the cable from the seal in the motor shield and remove it.
7. Install the parts in reverse order.
Visitor comments