Warning! Before performing the operation, be sure to read the section «Safety measures for the maintenance and repair of the engine management system».
Execution sequence
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Remove the engine trim (see «Decorative overlay of the engine - removal and installation»).
3. Disconnect the wiring harness block from the sensor using a thin slotted screwdriver.
4. Using the TORX E10 key, unscrew the sensor mounting bolt.
5. We remove the sensor from the intake manifold by prying it with a slotted screwdriver.
6. Disconnect the clamping bracket from the sensor.
7. Install the absolute pressure sensor in the intake manifold in reverse order.
Comment. Check the condition of the sealing ring. If there is damage, it must be replaced.
Visitor comments