Checking the condition of the timing belt (Opel Vectra C)

1. Scheduled replacement of the toothed belt and tension roller is carried out in accordance with the Maintenance Schedule (see Section 1).

2. In addition, these parts must be replaced if the following defects and malfunctions are detected during the inspection:

• Distinct noise from the idler/tensioner roller bearing both with and without the timing belt installed;
• When the belt is removed, the rollers produce a large number of revolutions when slightly pushed;
• Excessive oiling of rollers due to damage to bearing seals;
• Detection of traces of sand, dust or salt water on the working surfaces of the toothed belt, guide/tension roller;
• The toothed belt was found to have cuts or transverse tears in the top layer, lateral thickenings, abrasions and signs of wear on the sidewalls, cracks in the base of the belt, delamination, traces of oil and grease.

3. To access the timing belt, it is necessary to perform operations to prepare it for removal (see Chapter 2).

Source is on this resource: www.opelbook.ru