2. To remove the replacement element, you must first disconnect the connector (see resist. illustration) the electrical wiring of the mass air flow sensor by depressing the connector latches.
18.2 Sensor (3) mass air flow measurements: 1. Wiring connector; 2. Retainer
3. Loosen the mounting clamps (see illustration) and remove the intake air duct.
18.3 Air cleaner - the arrows indicate the cover fastening screws: 4. Mounting clamps; 5. Air inlet air duct; 6. Air cleaner cover; A. Lid holders
Remove the 5 mounting screws, then lift the end of the air cleaner cover on the engine side, release the opposite end of the cover from the holders and remove it. 4 Remove the filter element, wipe the inside surfaces of the air cleaner cover and body with a dry cloth, and install a new replacement element. Assembly is carried out in reverse order.
Attention! At the factory, the purifier air cover is fixed with self-tapping screws, they can be used no more than 10 times. If the cover is no longer tightly held on the air cleaner body, it is necessary to drill holes of a suitable diameter in the attachment points and use ordinary bolts with nuts to fasten the cover.
Visitor comments