Removing
1. Loosen the clamps and disconnect the large crankcase breather hose from the cylinder head cover
2. Remove the small crankcase ventilation hose.
3. Unscrew bolts of fastening and remove a cover of a head of the block of cylinders.
Installation
1. Clean the inner surface of the cylinder head from oil deposits. Check the condition of the oil separator filter in the cover and, if it is dirty, unscrew the bolts, remove it and wash it.
2. Check that the seal (arrow) located in the grooves of the cover, and install the cover on the engine.
3. Fasten the cover with bolts, tightening them to the required torque, and tightening in a diagonal sequence. When installing bolts, install brackets for fastening high-voltage wires under them (arrows).
4. Connect crankcase ventilation hoses.
Visitor comments