Replacing handbrake brake pads (Opel Vectra B)

On models with rear brake discs, the handbrake operates independently of the hydraulic brake system. In this case, drum-type brake shoes are used, and the inner part of the brake disc is used as a brake drum.

Location of the handbrake shoe retainer



Handbrake lever parts



Handbrake lever assembly



1. Remove the brake disc.



2. Clean dust and dirt from the backing plate and brake pads.



3. Using pliers, remove the brake shoe retaining spring plate by pressing the plate and turning it 90°.



Article posted on an online resource: www.opelbook.ru

4. Remove the spring and take out the retainer pin.



5. Mark the location of all handbrake components and remove the adjusting bar from the top of the brake shoes.





6. Using pliers, remove the upper return spring from the brake shoes.



7. Remove the lower return spring.



8. Remove the brake pads.



9. Using a screwdriver, disconnect the handbrake cable from the special bracket.





10. Disconnect the return spring from the support plate and remove the lever.



11. The handbrake pads can be installed in the reverse order of removal. However, it is most convenient to install the handbrake pads after removing the rear hub. In this case, it is necessary to temporarily secure the support plate with two bolts.



12. Assemble the handbrake lever by applying lubricant to the contact surfaces. Then install the lever to the support plate by inserting it through the window with the rubber seal.





13. Install the handbrake cable onto the lever.



14. Install the handbrake cable onto the mounting bracket.



15. Using pliers, clamp the mounting bracket.



16. Then install the return spring.





17. Apply a thin layer of high temperature grease to the areas where the brake pads contact the brake shield.



18. Install the front shoe.



19. Install the spring and brake shoe retaining plate.



20. Secure the spring and spring plate.





21. Install the rear brake shoe and install the lower return spring.



22. Install the brake shoe onto the lower support plate.



23. Install the spring and spring plate that secure the brake shoe to the brake shield.



24. Install the adjusting bar between the upper ends of the brake shoes.





25. Install the upper return spring.



26. Install the rear hub.



27. Temporarily install the brake disc on the brake pads. Using a screwdriver, turn the adjuster nut enough to allow the brake disc to be removed without jamming.

28. Install the brake disc.

29. Adjust the handbrake.

30. Install the wheels and lower the vehicle.