Multi-seat 1
It folds back.
To fold the seat:
- operate handle 3 and fold the backrest onto the seat cushion;
- grab the rods under the seat and bring them closer (movement A);
- tilt the entire seat forward until it locks into place.
To return the seat to its original position:
- pull the seat blades and fold them back until they lock into place.
Multi-seat 2
It can't be thrown back
Peculiarity: to make it easier to get to the back seat (multi-seat 1), release belt 4 from the lock in housing 4 and operate control 5 to recline seat back 2. Do not forget to re-fasten the belt when the seat is occupied.
When folding the seats back, make sure they are properly locked. It is also necessary to ensure that the side belts are correctly secured in the appropriate stoppers.
Removal and installation
Bench seats 1 and 2 are removed and folded in the same way. Seat 1 can be installed in the first or second row. Seat 2 can only be installed in the first row.
Removal
Before removing, release the side straps from the retaining housings. On each side of the bench seat, press the locking device button 3 and then pull it forward (movements A and B). Raise the bench seat (movement C).
Move the seat back to release it from the rear anchor points (d movement). Raise the bench seat (e movement). Slide the seat back again to release it from the front anchor points (f movement). Remove the seat.
Installation
Attach the seat to the front mounting points. Move the seat enough to properly fit the rear anchor points. Fix lever 3.
(Text copied from this portal: www.OpelBook.ru)
Visitor comments