All-wheel drive vehicles
It is necessary to remove air from the hydraulic system after any opening.
Remove the F19 fluid coupling valve fuse from the fuse box.
Loosen the air release screw on the fluid coupling valve by approximately 3 turns.
Add fluid to the tank up to the 1 ("MAX") mark.
Start the engine.
If the fluid level drops, immediately add fluid up to the 2 ("MIN") mark.
Article posted on an online resource: OPELBOOK.ru
Leave the engine running for about 15 minutes.
Turn the steering wheel from lock to lock several times, holding it in the extreme position for about 20 seconds.
Tighten the air bleed screw, wait 20 seconds, then loosen it again 3 turns.
After 20 seconds, tighten the screw to a torque of 1.5 Nm.
Turn off the engine.
Insert the fuse.
Turn on the ignition.
Press the brake pedal approximately 15 times.
Check the brake fluid level in the reservoir (with a warm engine (oil temperature around 80°C) the level should reach the "MAX" mark, with a cold engine - the "MIN" mark).
Visitor comments