Removal and installation the stabilizer (Opel Vectra A)

Removal

Loosen the stabilizer mounting bolts on the rear axle and remove the stabilizer.

Check the rubber buffers for wear or damage and replace if necessary.

Installation

Install the stabilizer and tighten its bolts to a torque of 22 Nm.

(Original posted on the website opelbook)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Zinoviev Kirill

Share information:

Opel Vectra A: Rear suspension

Removal and installation rear wheel hub bearings
Checking and adjusting the play of wheel hub bearings
Removal and installation rear springs
Removal and installation rear shock absorbers
Rear suspension. Design and general information

All-wheel drive vehicles
Bleeding air from the hydraulic system
Checking the level and adding oil to the transfer case
Checking the level and replacing the oil in the main gear
Checking axle shaft covers

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet