Removal and installation of door glass (Opel Vectra A)

Vectra cars

Removal

Remove the door trim.

Remove the protective film. Be careful not to tear it.

Lower the window completely.

Press out the pads and guides.



Remove the rear glass guide 1. To do this, unscrew the screw at the end of the door under the lock and pull the guide down.



Remove stop 2 from the upper guide of the lever.

(Original posted on the website: www.OpelBook.ru)



Loosen screws 1 securing the lower guide of the lever to the door. First mark the position of the screws.



Tilt the glass forward and lift it up out of the door.

Installation

Insert the glass into the door from above.

Place the stop on the upper guide.

Fix the lower guide according to the marks made. If the marks were not made, adjust the position of the glass before tightening the screws. To do this, slightly tighten the screws, move the glass up and down (the glass will automatically set itself in the correct position). Tighten the screws.

Press in the door seal.

Install the door trim.

Adjust the electric window lift (if equipped).