Front doors
1. Remove the inner door panel and water-repellent screen.
2. Disable the side airbag by disconnecting the battery from the ground and waiting 1 min. Loosen the bolts and remove the airbag sensor and bracket (note that the airbag sensors for the left and right doors are different).
3. Remove the rear power window guide by drilling out the rivets that secure the guide to the frame (see photo).
4. On models with the electric drive of glasses temporarily attach a wire to the switch of a window regulator and connect the battery to weight. Align the glass so that access to the power window mounting bolts is provided through the openings in the door frame, and unscrew the bolts (see photo). On other models, install the glass by replacing the handle.
5. Tilt the glass forward, remove the roller - rear guide (lower or raise the glass if necessary), move the glass up and out of the door (see photo).
6. Installation is carried out in the reverse order. Fasten the guide with new rivets. Bolts of fastening of a window regulator first tighten by hand, then raise the glass and lower it, then tighten the bolts.
Rear door glass (including fixed)
7. Remove the inner door panel and water-repellent screen.
8. On power window models, temporarily connect the wire to the power window switch and connect the battery to ground. On other models, reinstall the power window handle. Lower the glass.
9. Carefully remove the rear guide seal, first unscrew the top guide mounting bolt, then the bottom bolts (see photo).
10. Carefully lift the guide away from the fixed glass and remove it from the door (see photo).
11. Move the fixed glass forward and remove (see photo).
12. Tilt the glass forward, push up and out of the door (see photo). If necessary, remove part of the glass seal.
13. Installation is carried out in the reverse order.
Visitor comments