2. Insert the key into the lock, then remove the retaining ring (see photo).
17.2 Parts of the drum switch
1. Pin
2. Housing
3. Drum lock switch
4. Sleeve
5. Ball
6. Coupling
7. Case base
8. Retaining ring
9. Holder and lever
10. Return and pressure springs
11. Return and pressure springs
3. Disconnect the holder with the lever from the lock switch, remove the springs, paying attention to the initial position of these parts.
4. Mark the position of the lock body K relative to adjacent parts. Knock out the pin with a bar with a diameter of 2.5 mm.
5. Remove the lock, bushing, balls and switch sleeve.
Attention! The drum switch of the lock changes together with the switch clutch.
Visitor comments