Front door power window
1. Remove glass of a forward door. The further procedure for removing the power window is illustrated in the photo.
2. Installation is carried out in the reverse order. Fasten the guide with new rivets (see photo). On models with power windows, do the following:
A. From the driver's seat, close all doors.
B. Turn on the ignition and lower the glass a little.
B. Raise the window, press the power window switch and release after 2 seconds.
Rear door power window
3. Remove glass of a back door.
4. On models with electric windows, disconnect the battery from the ground, disconnect the connector from the electric drive.
5. Drill out 4 rivets and remove the rear door window lifter through the top opening in the door frame (see photo).
6. Installation is carried out in the reverse order. Fix the guide with new rivets. On models with power windows, set the power control unit to the state corresponding to the up position of the windows, following the procedures described in paragraph 2.
Visitor comments