Cover rack
1. Open the lid and have an assistant hold it.
2. Remove the spring clips from the cover posts, disconnect the legs from the ball joints (see photo).
3. Installation is carried out in the reverse order.
Lock
4. Remove the lower inner panel of the rear compartment partition.
5. Disconnect from the lock rod by removing the plastic clips (see photo).
6. Loosen the screws and remove the lock (see photo).
7. Installation is carried out in the reverse order.
Drum lock switch
8. Remove the bottom inner panel of the rear compartment cover.
9. Through the opening in the cover frame, remove the bracket and disconnect the rod from the lock (see photo).
10. Turn away nuts and remove the switch (see photo).
11. Installation of the lock switch is carried out in reverse order.
Lock latch
12. The latch is bolted to the bottom of the rear bulkhead (see photo).
13. For access to a clamp remove facing, having turned away screws, outline a contour and remove a clamp.
Lever
14. The handle of the rear compartment cover is attached to the cover with 2 nuts.
Visitor comments