Vectra/Calibra cars
Removal
Remove the door trim.
Peel off the protective film in the area of the door handle. Be careful not to tear the film.
Unscrew two nuts 1 (see fig.D1107) with a 10 mm wrench (for example, Hazet 428-10).
(Original source on the website OpelBook.ru)
Press down two clamps 2 (if any).
Disconnect the rod from the plastic adapter.
Remove the central lock switch (if any) by pressing the bracket down. Make sure that the bracket does not fall through.
Remove the cover.
At the same time, pull the door handle out from the door, tilt it down and remove it.
Installation
Insert the door handle into the door as shown in Figure D1121.
At the same time, put the door handle cover on from the inside so that the door handle on the side of the lock cylinder enters the hole in the cover.
When installing the door handle, insert the lock cylinder rod into the plastic adapter.
Secure the door handle cover with two nuts.
Install the central lock switch so that the guide pin enters the corresponding hole. In this position, fix the switch with the retaining spring.
Check the operation of the door handle and central lock.
Apply protective film, using double-sided tape if necessary.
Install the door trim.
Visitor comments