Contents: Removal ⬇ Installation ⬇
Removal
Disconnect the cable from the negative battery terminal.
Disconnect the connector (1) from the brake pedal limit switch.
Loosen the lock nut (2) of the brake pedal limit switch.
Remove the brake pedal switch from the panel.
Installation
Screw the brake pedal switch into the panel.
Adjust the position of the brake pedal limit switch so that the gap (A) between the end of the thread on the switch and the brake pedal is within 0.5-1.0 mm.
Tighten the lock nut.
Connect the connector to the brake pedal switch.
Connect the cable to the negative terminal of the battery.
Visitor comments